IF5317 (Discontinued) 500C Large Vacuum Oven with Vacuum Pump & Water Chiller DZF-6090-HT

Power

• Single Phase 208~240 VAC 50/60 Hz.
• 2600 W with 20A breaker required

Structure

• The chamber is structured with stainless steel and welded to bracing pieces.
• Two racks of SS304 heating plates inside the vacuum chamber to directly heat the chamber. Warning: never place samples directly on the heating plate, please use a ceramic sheet or stainless tray to hold samples
• Chamber material: 1Cr18Ni9Ti stainless steel
• Chamber size: 18 x 18 x 18", (460 x 460 x 460 mm, 91 Liter, 3.4 Cubic Feet)

Temperature Control

• Two programming temperature controls are equipped for discrete control on each heater
• 30 segments programmable with ± 1℃ accuracy
• Continuous working temperature: 50 - 500 ℃
• Max. working temperature: 550℃ f < 2 hours
• The maximum temperature difference between the two zones: 100℃.
• Temperature Uniformity: ±5℃ in 12x12x12" chamber center zone.
• The software and PC interface module is available at extra cost.

Vacuum Pump & Floating-Meter  

• Dual-stage vacuum pump with exhaust filter installed on the bottom.
• Maximum vacuum: <133pa or 2 Torr
• Built-in mechanical vacuum gauge
• One 1000 mL/min gas flowmeter for monitoring gas gauge, fill, and flow.
• One Rotary Vane Vacuum Pump with Exhaust Filter, Bellows & KF-D25 Inlet is included

Water Cooling

• One Digitally controlled Recirculating Water Chiller EQ-KJ5000 is included.
• Refrigeration range: 5~35℃
• Flowing range: 16L/minute
• Coolant tank capacity: 6 Liter
• Use anti-corrosion coolant for the best performance.

Warranty

• One-year limit warranty and lifetime support

Certificate

• CE Certification
• NRTL or CSA Certification is available upon request at extra cost.

Product Dimensions

• 610 x 690 x 1350 mm (24" x 27" x 53")

Shipping Weight & Dimensions

• 610 lbs.
• 48"x40"x65"

Application Notes

• For accurate temperature measurement, you may do calibration by using the temperature calibrating kit.
• For more information on how to calibrate the oven temperature, please read the document.

Attention

• After heating the oven to a high temperature, the chamber will be dulled and discolored. They are normal phenomena and will not affect the performance of the oven. All samples inside the chamber should not have any contact with the chamber wall.